COILS
Product List
※Excerpt
-
Edgewise coil
A rectangular edgewise coil made of a rectangular copper wire wound and folded to form two layers.
-
Edgewise coil
The mass is said to be 1 part copper to 1.6 parts aluminum, but an aluminum rectangular wire used in place of a round copper wire can be made very light without increasing its size.
-
Edgewise coil
This will free you from the trouble of connecting two coils and worries about the connection.
-
Edgewise coil
Hard wires such as resistance wire (iron-chromium alloy) are also wound.
-
Edgewise coil
A thin (0.2 mm) and wide (2.5 mm) edgewise coil (wound upright).
-
Edgewise coil
The coil was developed to reduce copper loss which occurs in motors and reactors shifting to high-frequency range as well as to reduce the high lamination factor.
-
Others
Higher heat resistance and higher withstand voltage than AIW. Thick film coating adds protection from harsh environments. Available with a “tight winding” with no bulging. Available with a round wire, too.
-
Edgewise coil
Coils used for low-torque generation such as a windmill.
-
Edgewise coil
A solution to your wish of “We want to wind even one more turn!”
-
Edgewise coil
-
Toroidal coil
Why not try a high laminating factor with a toroidal coil?
-
Edgewise coil
-
Edgewise coil
Processing of the leads is also possible.
-
Edgewise coil
Normal manufacture is three times and over of the wire width but the coil on the left is made for twice the size of the wire width. No problem in coating, either.)
-
Others
Coil modeling: Distributed
-
Others
Double wound coil modeling by concentrated winding.
Please click the following link to make an inquiry using the email form.
Information on how to contact URATANI ENGINEERING
for consultations or inquiries is given here.